DSC Evo Programming
Programming your new DSC Evolution remote to the alarm system.
Step 1: Locate the receiver. This is normally installed at a point in the premises that will maximise the range of the remotes.It is quite often installed in the ceiling. The receiver is pictured alongside the remote in the picture above.
Step 2: Open the receiver and identify the program button. This is labelled in the picture above.
Step 3: Press and release the program button. The LED will illuminate solid red.
Step 4: Press the Arm (upper left) button four (4) times or until the LED turns off. When the LED turns off the remote was successfully coded. All buttons are programmed.
The receiver will only learn 10 remote controls.