Adding a remote to the DTS 500 gate motor

PROGRAMMING TRANSMITTERS FOR FULL OPENING – BT LRN

  1. Push the BT LRN button on the motor’s PC board, the RX led will go on.
  2. Push the required button on the transmitter at arms length from PCB once, the RX led will flash.
  3. Press the same button again, the RX, Close & Open led will flash 3 times for a full Keeloq transmitter or twice for other transmitters.
  4. Repeat Step 1 and 2 for additional transmitters.

PROGRAMMING TRANSMITTERS FOR PEDESTRIAN OPENING – PD LRN

  1. Push the PD LRN button on the motor’s PC board, the RX led will go on.
  2. Push the required button on the transmitter at arms length from PCB once, the RX led will flash.
  3. Press the same button again, the RX, Close & Open led will flash 3 times for a full Keeloq transmitter or twice for other transmitters.
  4. Repeat Step 1 and 2 for additional transmitters.

Up to 31 transmitters can be programmed as a joint combination between BT LRN & PD LRN.

TO INDIVIDUALLY ERASE REMOTES

  1. Push and hold the BT LRN button for 5 seconds, the RX led will light up and the Close & Open led will flash once.
  2. Release the BT LRN button.
  3. Now push and release the remote button you want to erase, the RX, Close & Open led will flash twice as confirmation.
  4. The remote is now erased.

TO ERASE ALL REMOTES

  1. Push and hold the BT LRN button, after 5 seconds the RX led will light up.
  2. Keep holding for another 5 – 10 seconds then the Close & Open will start flashing.
  3. Release BT LRN button.
  4. The RX led will flash 5 times as indicating, all transmitters erased.